Description

Chemclean Steriliser – 100g

Chemclean is an alkaline cleaner

WHERE CAN I USE CHEMCLEAN?

Chemclean is very effective on stainless steel, soft metals, plastics and glass.

CAN CHEMCLEAN BE USED IN HARD WATER AREAS?

ARE THERE ANY MATERIALS I CANNOT USE CHEMCLEAN?

Do not use on Teflon-coated equipment.

WHAT IS THE DILUTION RATE?

For manual cleaning use 50g per 5 litres of water, for soaking use 50g per 20 litres of water. You can increase the dosage up to 5% depending on soil conditions.

HOW CAN I USE CHEMCLEAN?

You can use Chemclean for all types of cleaning, including soaking, manual scrubbing, and recirculation cleaning.

WHAT IS THE MINIMUM CONTACT TIME?

Contact time depends on the soil load, but you can typically soak equipment for up to 4 hours or use it in a recirculation system for 30 minutes.

AT WHAT TEMPERATURE SHOULD I USE CHEMCLEAN?

You can use Chemclean hot or cold, up to 60°C.

CAN I STORE AND REUSE THE DILUTED SOLUTION ONCE IT HAS BEEN MADE UP?

Chemclean will begin to dissociate after a few hours and will no longer be as effective however, you can reuse it to clean multiple pieces of equipment at the same time. Always make up fresh Chemclean solution immediately before using it.

MY CHEMCLEAN FOAMS UP A LITTLE, IS THIS RIGHT?

Chemclean can foam up when agitated but the foam quickly collapses when left to settle.

DO I NEED TO RINSE CHEMCLEAN?

Yes, Chemclean rinses off easily, so you should rinse it thoroughly, ideally with warm water, before sanitising with Chemsan.

HOW TO USE

Dilution: 50g per 5 litres of water for manual cleaning. 50g per 20 litres of water for soaking. You can increase the dosage up to 5% depending on soil conditions.

Preparation: Before cleaning remove as much loose soil as possible by rinsing equipment and vessels.

Manual Cleaning: Scrub all surfaces with the cleaning solution until all surfaces are clean.

Circulation Cleaning: Use 50g per 20 litres of water for fermenters, kegs, tanks, and other equipment. Circulate for 30 minutes at up to 60°C. Dilution and circulation time may need to be adjusted depending on soil load.

Soaking: Ensure all equipment to be cleaned is fully immersed. Soak for 4 hours at up to 60°C or allow to soak cold overnight. Thoroughly rinse equipment after cleaning. You can reuse the solution during the cleaning process. Do not use on Teflon-coated surfaces